Yiwu DECHO Foreign Trade Company

High quality product, professional service, being the core supplier in laser industry!

Home > News > Content
Plastic Slicer Operational Specifications
- Aug 01, 2017 -

In the conventional slice operation, it is difficult to adjust the cutting plane accurately. Plastic Slicer In order to simplify and standardize the operation of the slicing method, according to the practice of foreign literature and sections of conventional sections, Plastic Slicer we have summed up a method to adjust the standard cutting [1,2] plane of slicer,

When sliced for accurate cut to the tissue, Plastic Slicer usually when embedded in the organization will be gently pressed at the bottom of the embedded mold. Needle aspiration biopsy tissue is usually 10 ~ 20 mm, diameter <1 mm, Plastic Slicer so even if there is a slight cutting plane adjustment errors, it is easy to lead to biopsy from one end is not evenly cut off. The problem of adjusting the standard cutting plane may be more complicated when the sliced object is an almost transparent tissue. In addition, when tissue wax blocks are sliced on different slicers, changes in the cutting plane can lead to difficulties in slicing. For example, Plastic Slicer some laboratories cut the wax pieces on a slicer and distribute them to other slices, or wax The block is sent to the outer courtyard for consultation. Plastic Slicer In these cases, the error between the first cutting plane and the subsequent slicer is often caused by unnecessary cuts due to repeated cuts.

Before the formal operation, Plastic Slicer the standard paraffin tissue module was prepared according to the operation standard, and the wax block was parallel to the bottom plane of the model. There was no deviation between the front and the left and right sides. Secondly, Plastic Slicer the sliced chuck was adjusted to The X-axis is nearly parallel to the cutting edge, and the Y-axis is nearly perpendicular to the blade; the cutting plane thus obtained is called the standard cutting plane of the slicer. It can be applied to one or more slicers when it is relatively fixed, stationary, Plastic Slicer batch or continuous processing. The sectioning method not only regulates and simplifies the slicing operation, but also avoids the cumbersome and insecure factors caused by the random adjustment of the cutting plane, Plastic Slicer and more importantly, greatly improves the efficiency of the slices and the quality of the slices.

The adjustment of the cutting plane of the slicer is accomplished by the three main adjustment knobs of the X axis, Y axis and lock knob. When operating, loosen the lock knob to prevent further movement of the mechanism when a satisfactory cutting plane is obtained. For different slices of origin and type, Plastic Slicer the precise steps for adjusting the cutting plane may vary slightly depending on the type of specimen chuck and adjustment system installed, and the operator can adjust the instructions according to the slicer's manual. Plastic Slicer In order to cope with the smooth adjustment of the cutting plane, in the embedding of the organization should also strengthen the plastic box used in the operating specifications, that is, to be embedded at the bottom of the model began to solidify the paraffin and then cover the box, Plastic Slicer Add wax. The purpose of this is to make the embedding box more secure in contact with the tissue wax, to reduce and prevent the tremor when cutting or embedding the box and the tissue wax.