When sliced for accurate cut to the tissue, Plastic Slicer usually when embedded in the organization will be gently pressed at the bottom of the embedded mold. Plastic Slicer Needle aspiration biopsy tissue is usually 10 ~ 20mm, diameter is <1mm, so even if there is a slight cutting plane adjustment errors, it is easy to lead to biopsy from one end of the cut off the uneven. When the sliced object is an almost transparent tissue, Plastic Slicer the problem of adjusting the standard cutting plane may be more complicated. In addition,Plastic Slicer when tissue wax blocks are sliced on different slicers, changes in the cutting plane can cause difficulties in slicing. For example, Plastic Slicer some laboratories cut the wax pieces on a microtome and then distribute them to other slices, or wax The block is sent to the outer courtyard for consultation. Plastic Slicer In these cases, the error between the first cutting plane and the subsequent slicer is often caused by unnecessary cuts due to repeated cuts.
Before the formal operation, the standard paraffin tissue module was prepared according to the operation standard, and the wax block was parallel to the bottom plane of the model. There was no deviation between the front and the left and right sides. Secondly, the blank chuck was adjusted to The X-axis is close to the blade and the Y-axis is close to the blade. The cutting plane thus obtained is called the standard cutting plane of the slicer. Plastic Slicer It can be relatively fixed, remain immobile, batch or continuous processing of the slice operation, you can apply on one or more slicers. The slicing method not only regulates and simplifies the operation of the slices, avoids the cumbersome and insecure factors that can be manipulated by the arbitrary adjustment of the cutting plane, but also greatly improves the efficiency of the slices and the quality of the slices. The adjustment of the cutting plane of the slicer is accomplished by the three main adjustment knobs of the X axis, Y axis and lock knob. When operating, Plastic Slicer loosen the lock knob to prevent further movement of the mechanism when a satisfactory cutting plane is obtained. Plastic Slicer For different slices of the origin and type, the precise steps for adjusting the cutting plane may vary slightly depending on the type of specimen chuck and adjustment system installed, and the operator can adjust the instructions according to the slicer's manual. In order to cope with the smooth adjustment of the cutting plane, in the embedding of the organization should also strengthen the plastic box used in the operating specifications, that is, Plastic Slicer to be embedded at the bottom of the model began to solidify the paraffin and then cover the box, Add wax. The purpose is to make the embedding box more secure in contact with the tissue wax, to reduce and prevent tremors from the slices or to fall off the box and tissue wax. Plastic Slicer In addition, it should be noted that the second wax can not be overfilled, Plastic Slicer otherwise the wax block can not be exactly coincident with the slicer fixture, resulting in loose pieces when slicing, affecting the quality of slices.
- Classification Of Gift Bags
- Non-woven Bag Introduced
- The Principle Of Non-woven Bags
- The Basic Process Of Non-woven Bags
- The Advantage Of Non-woven Bags
- Clothes Storage Basket The Purpose ...
- How To Use A Ring Peeling Oranges
- What Is An Inflatable Pillow
- Why Choose Non-woven Bag
- Tell Non-woven Fabric
- Non-Woven Bag Specialty
- Plastic Slicer Performance
- Non-Woven Bag Good Ventilation
- Plastic Slicer Operational Specific...
- General Lazy Mobile Phone Support T...
- Non-Woven Bag Good Air Permeability
- Plastic Slicer The Usefulness Of
- Non-Woven Bag Waterproof Performance
- Plastic Slicer Specifications
- Non-Woven Bag The Difference Betwee...